On site across Algeria
CO2 laser and CNC machine repair
The laser no longer fires, an axis no longer moves, the spindle won’t start? We diagnose and repair the electrical and electronic side of CO2 laser cutting and engraving machines and of CNC machines (routers, plasma, lathes), on site anywhere in Algeria or in our workshop for boards.
CO2 laser machines: electrical and electronic side
- Laser high-voltage power supply: diagnosis, repair or replacement
- Controller board (Ruida, Trocen, Leetro): diagnosis, repair or replacement
- Stepper drivers and motors, limit switches and homing
- Wiring, door interlocks and the tube’s water-flow protection
CNC machines: routers, plasma, lathes
- Spindle and its drive: set-up, wiring and repair
- Axis stepper or servo drivers and motors, limit switches
- DSP, Mach3 / Mach4, NcStudio, Syntec controller: set-up and replacement
- Partial or complete rebuild of the electrical cabinet
How it works
- You send a video of the fault and a photo of the cabinet on WhatsApp
- Diagnosis on site, or board and power supply repaired in our workshop in Médéa
- Free quote before any repair
- Tests on the machine with your operators

Brands and software
- Ruida
- Trocen
- Leetro
- DSP
- Mach3 / Mach4
- NcStudio
- Syntec
- ABB
- Schneider Altivar
- Siemens Sinamics
- Danfoss
- LS
- INVT
- Delta
- Xinje
- Chint
- Nietz
How it works
- 1
You describe the machine or the project by phone, WhatsApp or with the form (photos and part numbers welcome).
- 2
We study the need and send you a free quote before any work.
- 3
We work on site or in the workshop, with tests and a backup handed over at the end.
Frequently asked questions
My CO2 laser no longer fires: what could it be?
Often the high-voltage power supply, the command sent by the board, or an open safety (door, water flow). We check these first. If the tube is worn, we tell you after the diagnosis: the tube and optics are not part of our repairs.
A CNC axis no longer moves or loses position: what should I do?
Send a video of the fault and the part numbers of the driver and motor. Common causes are the driver, the motor, a cable or the controller settings. We diagnose on site and repair or replace the faulty part.
Can you replace my machine’s controller?
Yes, for laser controllers (Ruida, Trocen, Leetro) and CNC controllers (DSP, Mach3 / Mach4, NcStudio, Syntec): replacement, wiring and set-up, then tests with your operators.
Do you repair boards and power supplies in the workshop?
Yes. Boards and power supplies can be sent or dropped at our workshop in Médéa; we send you the diagnosis and the quote before repairing.
How much does a repair cost?
It depends on the fault and the travel. Send a video of the fault on WhatsApp: the quote is free and you receive it before any repair.
Further reading
Our other services
- PLC programming
- HMI and SCADA programming
- Factory SCADA supervision
- Pumping station remote monitoring
- VFD and servo set-up
- Injection moulding machines
- Machine program backup
- Migration and modernisation
- Electrical design and instrumentation
- Generator installation and repair
- Maintenance contract
- All our services
Tell us about your machine
Quick answer by phone or WhatsApp, free quote before any work, anywhere in Algeria.



