Skip to content

On site across Algeria

Generators: installation, transfer switch and repair

Power cut and the generator won’t start? It starts but won’t take the load? The voltage is unstable? We install and repair generators of every size and brand: automatic transfer switch panel, controller, voltage regulator (AVR), alternator and servicing, on site anywhere in Algeria.

Installation and automatic transfer switch

  • Connecting the generator to the switchboard: cables, protection, earthing
  • Automatic transfer switch panel (mains / generator): supply, wiring and settings
  • Automatic start on power cut, return to mains and stop after cool-down
  • Tests under real load with you at commissioning

Controllers: DeepSea, ComAp, SmartGen, Datakom

  • Generator won’t start, stops by itself or shows an alarm: diagnosis
  • Controller replacement and set-up (thresholds, timers, automatic start)
  • Sensor checks: oil pressure, temperature, level, speed
  • Battery, charger, starter motor and fuel solenoid

Alternator and voltage regulator (AVR)

  • Voltage too low, too high or unstable, no output voltage
  • AVR check and replacement, voltage adjustment
  • Check of the alternator excitation and windings
  • Measurements under load: voltage, frequency and current per phase

Preventive servicing

  • Periodic visit: battery, oil, filters, coolant, belts
  • Start test and load test
  • Check of the transfer switch and protection
  • Visit report with the points to plan; can be part of a maintenance contract
Generators: installation, transfer switch and repair

Brands and software

  • DeepSea (DSE)
  • ComAp
  • SmartGen
  • Datakom

How it works

  1. 1

    You describe the machine or the project by phone, WhatsApp or with the form (photos and part numbers welcome).

  2. 2

    We study the need and send you a free quote before any work.

  3. 3

    We work on site or in the workshop, with tests and a backup handed over at the end.

Frequently asked questions

My generator won’t start: what should I do?

Note the alarm shown on the controller and send a photo or video on WhatsApp. Common causes are the battery, the starter motor, the fuel supply, an emergency stop or a faulty sensor. We check these first on site.

The generator starts but won’t take the load during a power cut: why?

Often the transfer switch (contactors, control, settings) or the controller not giving the order. We check the whole chain: power-cut detection, start, changeover and return to mains.

The generator voltage is too low or unstable: where does it come from?

Often the voltage regulator (AVR), the alternator excitation or a badly set engine speed. We measure under load, then adjust, repair or replace the faulty part.

Can you add a transfer switch to an existing generator?

Yes. We supply and wire the automatic transfer switch panel, set the generator controller for automatic start and run the tests with you.

Which brands and sizes?

All generator brands and sizes. For controllers, we work in particular with DeepSea, ComAp, SmartGen and Datakom.

How much does it cost?

It depends on the fault, the generator size and the travel. Send a photo of the generator nameplate and controller on WhatsApp: the quote is free and you receive it before any work.

Tell us about your machine

Quick answer by phone or WhatsApp, free quote before any work, anywhere in Algeria.

Request a quote

Describe the fault or the project, and we will reply quickly with questions or a proposal.

Please give at least a phone number or an email so we can reply.

Photos (optional)

Nameplate, board, panel or fault code on the display: up to 3 photos to help us understand the fault.

Send via WhatsApp