On site across Algeria
Variable speed drive and servo drive set-up
A new, replaced or repaired drive only works well when it is set up correctly for its motor and its machine. We set up and commission variable speed drives and servo drives, on their own or controlled by the PLC, anywhere in Algeria, and we hand you the list of parameters.
Variable speed drives
- Set-up from the motor nameplate: current, speed, ramps, limits and protections
- Autotuning (motor identification)
- Control from terminals, preset speeds or the PLC (Modbus, Profinet)
- Replacing a drive with another model or brand, carrying over the settings
- Reading fault codes and correcting the settings
Servo drives and servo motors
- Commissioning of the servo drive and servo motor: Xinje, Delta, ABB, Chint, Nietz
- Autotuning and gain tuning for stable motion
- Position, speed or torque modes, homing
- Control from the PLC and the HMI
What you get
- A backup of each drive’s parameters
- Tests on the machine with your operators

Brands and software
- ABB
- Schneider Altivar
- Siemens Sinamics
- Danfoss
- LS
- INVT
- Delta
- Xinje
- Chint
- Nietz
How it works
- 1
You describe the machine or the project by phone, WhatsApp or with the form (photos and part numbers welcome).
- 2
We study the need and send you a free quote before any work.
- 3
We work on site or in the workshop, with tests and a backup handed over at the end.
Frequently asked questions
Our drive was replaced: can you set it up?
Yes. We carry over the old drive’s settings when they can be read; otherwise we set it up from the motor nameplate and how the machine works, then test it with your operators.
Do you set up servo motors?
Yes, including Xinje, Delta, ABB, Chint and Nietz: servo drive commissioning, autotuning, gain tuning, position, speed or torque mode, and the link with the PLC. Send us the part number of the servo drive and motor.
The drive shows a fault code: what should I do?
Send the drive’s part number, the code shown and a photo of the motor nameplate on WhatsApp. Many faults come from the settings; when the drive is damaged, we repair it in the workshop.
What should we prepare before the visit?
The drive’s part number, a photo of the motor nameplate, the wiring diagram if you have one, and a description of what the machine must do (speeds, starts, stops).
Further reading
Our other services
- PLC programming
- HMI and SCADA programming
- Factory SCADA supervision
- Pumping station remote monitoring
- Injection moulding machines
- Machine program backup
- CO2 laser and CNC machine repair
- Migration and modernisation
- Electrical design and instrumentation
- Generator installation and repair
- Maintenance contract
- All our services
Tell us about your machine
Quick answer by phone or WhatsApp, free quote before any work, anywhere in Algeria.



