Skip to content

On site across Algeria

Injection moulding machines: programming, set-up and repair

When an injection moulding machine stops, the whole production stops. We work on the electrical and electronic side of the machines: Techmation and Porcheson controllers, machines run by a PLC and an HMI, servo pumps and drives, electronic boards. Horizontal and vertical plastic injection machines, shoe-sole machines and PET blow moulders, on site anywhere in Algeria or in our workshop in Médéa.

Programming and changes

  • Cycle changes: sequences, core pulls, ejector, mould opening and closing
  • Adding an output or a signal for a robot, a conveyor or other equipment
  • PLC-controlled machines: PLC program and HMI screens
  • Backup of the program and the machine parameters

Configuration and set-up

  • Machine parameters of Techmation and Porcheson controllers
  • Calibration of the position transducers (clamp, injection, ejector) and pressure sensors
  • Heating zones: thermocouples, temperature control, solid-state relays
  • Proportional pressure and flow valves: adjustment and checks

Servo pump, drive and repair

  • Commissioning and set-up of the servo pump or the hydraulic pump’s drive
  • Repair of drives and servo drives (IGBT modules, rectifier bridges, capacitors)
  • Repair of controller boards, heater boards, valve amplifiers and power supplies
  • Electrical cabinet diagnosis: alarms, sensors, door safety switches, emergency stop
Injection moulding machines: programming, set-up and repair

Brands and software

  • Techmation
  • Porcheson
  • Siemens
  • Delta
  • LS
  • INVT

How it works

  1. 1

    You describe the machine or the project by phone, WhatsApp or with the form (photos and part numbers welcome).

  2. 2

    We study the need and send you a free quote before any work.

  3. 3

    We work on site or in the workshop, with tests and a backup handed over at the end.

Frequently asked questions

Which injection machine controllers do you work on?

Techmation and Porcheson controllers, common on Chinese and Taiwanese machines, and machines controlled by a standard PLC with an HMI. Send us a photo of the screen and of the machine’s nameplate.

Our machine shows an alarm and won’t start: what should we do?

Send the alarm text or number, a photo of the screen and the machine brand on WhatsApp. Many stops come from a sensor, a position transducer, a door safety switch or a heating zone; we tell you whether an on-site visit is needed.

Do you repair the machines’ boards and drives?

Yes, in the workshop: controller boards, heater boards, valve amplifiers, power supplies, drives and servo drives. For example, we repaired the LS drives of a shoe-sole injection machine (rectifier bridge, IGBT module, capacitors).

Do you also work on PET blow moulders and shoe-sole machines?

Yes, on their electrical and electronic side: PLC, screen, heating, drives and boards.

Can you back up our machine’s parameters?

Yes. We record or back up the parameters and the program when the controller allows it, so the machine can be restarted quickly after a breakdown or a board change.

Tell us about your machine

Quick answer by phone or WhatsApp, free quote before any work, anywhere in Algeria.

Request a quote

Describe the fault or the project, and we will reply quickly with questions or a proposal.

Please give at least a phone number or an email so we can reply.

Photos (optional)

Nameplate, board, panel or fault code on the display: up to 3 photos to help us understand the fault.

Send via WhatsApp